ADI公司的ADAU1787Z是集成了两个低功耗音频DSP的和两个输入和一个输出的CODEC,模拟输入到DSP核到模拟输出的通路进行优化,以到到低等待和非常适合于手持设备的噪音消除.仅需要增几个外接的无源元件, ADAU1787Z就提供噪音消除耳机解决方案.ADAU1787Z具有可编程FastDSP音频处理引擎,高达768kNz取样速率.器件具有双四元滤波器,限幅器,音量控制和混合器,28位SigmaDSP音频处理核,高达50MIPS性能,低等待24位ADC和DAC,96dB SNR(信号通过带A加权滤波器的PGA和ADC),105dB组合SNR(信号通过带A加权滤波器DAC和耳机),频率8kHz到768kHz的串口fSYNC,模拟输入到模拟输出的群时延5μs(取样频繁768kHz),PLL支持30kHz到27MHz的任何输入时钟速率,具有全双工4路ASRC,主要用于噪音消除的手持设备和耳机,蓝牙ANC手持设备和耳机,个人导航设备(PNA),数码相机和视频摄像机,乐器效应处理器,多媒体扬声器系统和智能手机.本文介绍了ADAU1787Z主要特性,功能框图,以及评估板EVAL-ADAU1787Z主要特性,电路图,材料清单和PCB设计图.
The ADAU1788 is a codec with two inputs and one output that incorporates two digital signal processors (DSPs). The path from the analog input to the DSP core to the analog output is optimized for low latency and is ideal for noise cancelling headsets. With the addition of just a few passive components, the ADAU1788 provides a noise cancelling headphone solution.
Note that throughout this data sheet, multifunction pins, such as BCLK_0/MP1, are referred to either by the entire pin name or by a single function of the pin, for example, BCLK_0, when only that function is relevant.
Programmable FastDSP audio processing engine
Up to 768 kHz sample rate
Biquad filters, limiters, volume controls, mixing
28-bit SigmaDSP audio processing core
Visually programmable using SigmaStudio
Up to 50 MIPS performance
Low latency, 24-bit ADCs and DAC
96 dB SNR (signal through PGA and ADC with A-weighted filter)
105 dB combined SNR (signal through DAC and headphone with A-weighted filter) Serial port fSYNC frequency from 8 kHz to 768 kHz
5 μs group delay (fS = 768 kHz) analog in to analog out
2 single-ended analog inputs, configurable as microphone or line inputs
4 digital microphone inputs
1 analog differential audio output, configurable as either line output or headphone driver
PLL supporting any input clock rate from 30 kHz to 27 MHz
Full-duplex, 4-channel ASRCs
16-channel serial audio port supporting I2S, left justified, or up to TDM16
8 interpolators and 8 decimators with flexible routing
Analog AVDD at 1.8 V typical
Digital I/O IOVDD at 1.1 V to 1.98 V
Digital DVDD at 0.9 V typical
Low power (8.030 mW for typical power consumption)
I2C and SPI control interfaces
42-ball, 0.35 mm pitch, 2.695 mm×2.320 mm WLCSP
Noise cancelling handsets, headsets, and headphones
Bluetooth ANC handsets, headsets, and headphones
Personal navigation devices
Digital still and video cameras
Musical instrument effect processors
Multimedia speaker systems
Evaluating the ADAU1787 Four-ADC, Two-DAC, Low Power Codec with Audio DSPs This user guide explains the design and setup of the EVAL-ADAU1787Z evaluation board.
This evaluation board provides access to all analog and digital inputs/outputs on the ADAU1787. The ADAU1787 core is controlled by Analog Devices, Inc., SigmaStudio® software, which interfaces to the EVAL-ADAU1787Z via a USB connection.The EVAL-ADAU1787Z can be powered by the USB bus or by a single 3.8 V to 5 V supply. Any of these supplies are regulated to the voltages required on the EVAL-ADAU1787Z. The printed circuit board (PCB) is a 6-layer design, with a ground plane and a power plane on the inner layers. The EVAL-ADAU1787Z contains connectors for external microphones and speakers. The master clock can be provided externally or by the on-board 24.576 MHz passive crystal.
Multifunction pin names may be referenced by their relevant function only, for example, MPx, throughout this user guide.
EVAL-ADAU1787Z evaluation board
EVAL-ADUSB2EBZ (USBi) communications adapter
USB cable with mini USB plug